I tried firmware 1.1.18, did bench test with 24+1 distributor.
Checked inputs ic1 and ic3 on processor with scope and pulses come in nicely.
Still i dont get rpm.
Extract of my config :
primary_trigger=03
secondary_trigger=19
tooth_wheel=18
trigger_tooth=00
another_trigger_tooth=06
crank_minper=00
tooth_wheel_twidth1=78
tooth_wheel_twidth2=00
cam_sync_r_edge_phase=03
cam_sync_f_edge_phase=03
reset_engphase_after=40
ign_tdcdelay=78
ign_dwell14=30
ign_dwell6=4A
ign_crank_advance=3C
ign_out=70
ignchmax=03
Can someone explain what is wrong?
Can someone help me setup following :
Crank VR sensor with 8 evenly spaced teeth
Cam VR sensor with 1 tooth
This is called InputTrigger/MultiToothNoneMissing, 16+1
I've connected crank VR to trigger1 and cam VR to trigger2
How do i setup primary and secondary trigger?
What firmware should I use? 1.1.x
(and matching megatune, a recent 1.1.x)
How do i connect? I've got crank signal on IC1 and cam signal on IC3. Or does this only work when ordered with auditrigger?
I did test setup with 24+1 distributor firmware 1.0.73 (afaik 1.0.73 never supported InputTrigger/MultiToothNoneMissing )
RPM is indicating way too high. Setting rpm constant to 500 displays correct rpm.
For the hayabusha special 24-4 wheel the multitooth advanced filter can be used to set a "missing tooth detection threshold" different than 1.5
- primary_trigger=09 (not 01)
- advanced filter parameters according to threshold
- toothrel_normal
- toothrel_missing