Can someone help me setup following :
Crank VR sensor with 8 evenly spaced teeth
Cam VR sensor with 1 tooth
This is called InputTrigger/MultiToothNoneMissing, 16+1
I've connected crank VR to trigger1 and cam VR to trigger2
How do i setup primary and secondary trigger?
What firmware should I use? 1.1.x
(and matching megatune, a recent 1.1.x)
How do i connect? I've got crank signal on IC1 and cam signal on IC3. Or does this only work when ordered with auditrigger?
I did test setup with 24+1 distributor firmware 1.0.73 (afaik 1.0.73 never supported InputTrigger/MultiToothNoneMissing )
RPM is indicating way too high. Setting rpm constant to 500 displays correct rpm.
For the hayabusha special 24-4 wheel the multitooth advanced filter can be used to set a "missing tooth detection threshold" different than 1.5
- primary_trigger=09 (not 01)
- advanced filter parameters according to threshold
- toothrel_normal
- toothrel_missing