Want to install on Honda S2000
Trigger setup is as follows :
1 crank VR with 12 even spaced teeth
MembersPage/PhatBob - I understood that the crank trigger was 12+1 (12 even spaced teeth with one extra tooth in between on tooth pair)
MembersPage/MustangStef - I double checked and it is 12 even spaced teeth, camshafts as below. Any ideas how to process this?
1 VR on inlet camshaft with 4-1 teeth
1 VR on exhaust camshaft with 4-1 teeth
Is it possible to use the crank sensor together with one of the cam sensors?
If so, how should i configure trigger settings?
MembersPage/PhatBob We have 12+N triggers working, the 4-1 teeth on the cams is going to need something clever to deal with, It might be possible to get something working with the short gap trigger code described here:
http://www.vems.hu/wiki/index.php?page=InputTrigger%2FShortGapTrigger
Would it be best to remove 2 teeth from the camshaft. Then we have 12 teeth on crank and 1 on cam. Set primary trigger to coil type and activate camsync would do the trick i suppose?