I have a Volvo B230 4 cyl 8 valve engine with simple trigger:
- Two teeth on crank at about 80 degrees before TDC
- Camsync occuring at TDC.
It takes "forever" to sync and sometimes fires up immediately, it never complains about trigger errors but one thing is clearly seen :
- At first the status flag "Running" turns on/off and there is no rpm signal.
- Then suddenly the "Cranking On" flag turns on and it starts and runs fine.
If I run firmware pre 1.2.x it will sync and start immediately.
- What can I do about improving this for 1.2.0+ firmware?
- Are there any settings I have missed?
I have tried this on a V8 with only 90 degrees between crank teeth, it was almost impossible to get it starting. Downgrade to 1.1.96 and it fires right up every time.
Here is a typical cranking sequence, and clear to see seven (7) crank rotations before it syncs - with no fuel, so it didn't start, only for triggerlog cranking.
Here are my basic settings, anything to be changed here?
