ECUs sent in for repair 2018
11440
- Power touched bare wire on RS232 port (connector without housing) and customer has has intermittent communication since that time.
- Customer has tried different USB serial port adapters and in another car/harness as well.
- My personal tests on my test bench show no issues, tried with a desktop computer with proper serial port and laptop with known good USB serial port adapter.
- Perform your tests and report back. Even if you find nothing wrong, please replace the RS232 chip (customer request).
4153 and 4254
- Have recently been returned from you but it is as if nothing has changed, you still can not get a lambda signal.
- The current draw from the heater is only a few 100 mA and the sensor doesn't get hot to the touch.
- are you sure it's not the heater +12V or similar (sg in the harness) ? The heater - FET output was tested with >1A load
- As described last time, both ECUs has lost the wideband signal after moisture got into lambda sensor connector.
- My guess : Voltage from the fused power has probably trickled into the other pins in the lambda connector and damaged the input/control circuitry, and/or possibly the heater FET as well. Please try free-air calibration with a real sensor (it doesn't work) and report back what you find in Wiki.
- Please add 27k nernstpullup resistor to enable LSU 4.9 support if you get them working.
- Board replacement granted in worst case scenario
ECUs sent in for repair 2017
All of the ECUs listed below will not be used in the projects they came from. I've replaced the ECUs already and fixed any/all issues that caused the problems.
Check function of the boards and report back any issues, or return to me if healthy after quick fix.
I authorize mainboard replacement if necessary in all cases.
3399
- Stepper chip removed by customer after short in the coil harness (heat radiation).
- PCB damaged around stepper chip, do not replace chip - just leave as is.
4153
- No lambda sensor signal after water came into lambda sensor connector.
4254
- No lambda sensor signal after water came into lambda sensor connector.
4770
- No lambda sensor signal after water came into lambda sensor connector.
- Replaced by 17319 IGBT 2+6, LCD, Knock, 1xEGT, VR+Hall, 400 kPa
8098
- Outputs shorted to power in standard BMW M50 harness (heat melted wires).
- I removed one injector FET and one ignition IGBT that had shorted.
- There could be more damages.
- Replaced by 14365 2xEGT, VR+Hall, 400 kPa
10115
- ECU has never been used, only test bench.
- It has the bootup/reset problem. I tried the simple fixes with components sent by Marcel but it did not help.
- www.vems.hu/download/v3/doc/assembly/v3_mainboard_resetChips_variants.pdf
- Replaced by 18357 LCD, Knock, EGTx2, Hall+Hall
11820
- Stepper output shorted to +12V in harness (yes resistor in series now in place).
- Symptom is a 250 mA current draw, no VR trigger, possibly damaged P259.
- Replaced by 17039 LCD, Knock, 1xEGT, VR+Hall, 400 kPa, SD Card removeable
14821
- Same as 11820
- Stepper output shorted to +12V in harness (yes resistor in series now in place).
- Symptom is 250 mA current draw, no VR trigger, possibly damaged P259.