A customer has a 3B Pnp (board v3.7 # 6651) and wants to run 60-2 Hall for the primary trigger. Some easy steps I've done :
- Enabled Hall primary trigger : SJ2 closed, SJ6 open, R30 2.7k
- Disconnect LM1815pin12 output from the microcontroller input pin : Removed SJ7 solder-blob on the bottom
According to [wiki link] this should be enough.
- actually this is the only step required if converting from sectrig=auditrigger (because that already has the HALL part of the circuit set up from EC36/13)
- What about the transistor, yellow wire, and heat shrinked through-hole resistor ?
![[Image of trigger component area]](http://www.vems.hu/files/MembersPage/MattiasSandgren/AudiPnp/audi-3b-hall-hall.jpg){kind=link}