Subpage of MembersPage/MarcellGal/WoodGasifierEngine
Crysler Magnum 5.2L V8 engine wiring. Some parts are in Hungarian
ignition output - currently using 1 distributer
Ignition coil primary is connected between:
- EC36/36 (not 26 !!!!!!!!!!!!!!!!!!!!!!) ign coil-
- +12V
Fuse (BiztosÃték fontos!): 4-7.5A
Sensors
- primary trigger HALL (8 window on crank), EC36/27
- secondary trigger HALL (1 window on cam), EC36/13
- internal MAP (csovel csatlakozik a MAP)
TPS sensor
- EC36/1 TPS signal (this was only wrong in the sent .xls or connected wrong ?)
- EC36/29 TPS +5V
- EC36/26 TPS ground (signal GND)
Stepper outputs
coil1: (resistance= ?)
- EC18/..
- EC18/..
coil2: (resistance= ?)
- EC18/..
- EC18/..
Install initial steps
- download http://www.vems.hu/download/v3gui/ 2010-04-28
- if things don't go smooth, we'll need to try different version, but let's start with this
- install RS232 driver. if pl2303 than prolific.com.tw
- http://www.prolific.com.tw/eng/FAQs.asp?ID=50
- http://www.prolific.com.tw/eng/downloads.asp?ID=31
- http://www.prolific.com.tw/support/files/\IO Cable\PL-2303\Drivers - Generic\Windows\allinone\PL2303_Prolific_DriverInstaller_v1210.zip
- TerminalProgram - to verify RS232
- Bray-terminal is very good (hyperterm is very bad) but any could work.
- 19200,8,n,1 (flow control: off)
- even if these
- start VemsTune
- set serial port (might need to restart vemstune)
- take note of the firmware version (firmware info)
- Tools / firmware / upload firmware 1.1.27 (16x14)
- download config from ...
- upload config (select the just downloaded file)
- reboot
- verify MAP (must be 101 kPa)
- MAP calibration: select MAP sensor range 104, 250, 304 or 416 (so MAP is close to 101)
- finetune MAP sensor offset (so MAP=101)
- verify TPS:
- from 0-max take note of values