MembersPage/Kryniu/ToyotaSupra2jzgte
MembersPage/Kryniu/AudiA82.220VT953hp
Trigger 24+1 (C024 pattern)
- crankshaft 12 teeth VR without missing teeth
- ("next trigger tooth" = 30 crankdeg)
- camshaft 1 teeth VR two sensors
- what is the angular position before and after the campulse (to previous cranktooth and next cranktooth) ?
- eg. (delete this comment when writing real result) 13/17 and 16/14 ?
- InputTrigger/TriggerLog will tell easily (capture and upload to FileArea, and link here).
Must I grind 1 teeth from cranck wheel?
Normally no. The engine can run in camsync with 12 tooth wheel and 1 pin camshaft (if the sectrig is always between 2 given primtrig pulse, not too close to neighbor primtrig tooth and sometimes overtaking eg. at quick revvup). That is usually the case, but verify.
A: No tooth grinding required, the 24+1 trigger pattern is supported by VEMS.
do you have some initial config or configuration primary and secondary triggers for this engine??
MY INITIAL CONFIG
problem is when im crancking VEMS sees the engine speed after 2 seconds in log you see when im starting crancking the battery level going down and after 2 second vems see rpm
trigger log
vems log
This issue (long cranking with simpletrigger + camsync has since been fixed) for more details see: GenBoard/UnderDevelopment/FirmwareChanges. Upgrade firmware to 1.2.16 to make use of this fix - DB
Cranking fix is working good
new problem secondary trigger pos bad
trigger log
vemslog
A: This trigger error can be safely ignored for now, it sometimes comes up because conditions for it are a bit too strict, this will be fixed in up coming release under testing. -DB
LAUNCH CONTROL DONT WORK
When im activate switch on my clutch launch flag is green but dont work when im revs my engine speed is the same at rev limiter (7000) on launch i have (4000rpm)
when im turn launch always on then work perfect
vems log
A: When launch control rpm curve is enabled, you need to set up the curve with desired rpm limits (currently all set at 25500 in your config). More elaboration in F1 help menu for Launch Control.
new config with right launch setup and launch stil don`t work
cnfig file
http://www.vems.hu/files/MembersPage/kryniu/v3.3_u008415-A-2013.12.04-09.29.33.vemscfg
A: Your launch input does not switch fully to ground (but is stuck at 1.32v), you need to pull below 0.9v to activate (and above 1.56v to deactivate). Make sure you use an input with internal pull-up to 5v and apply an external switch to ecu GND (not power-ground or other).