MembersPage/Kryniu/ToyotaSupra2jzgte
Trigger
crankshaft 12 teeth vr without missing teeth
camshaft 1 teeth vr two sensors
my question is
do I must grind 1 teeth from cranck wheel?
Maybe engine can run in camsync with 12 teeth coil whell and 1 pin camshaft.
A: No tooth grinding required, the 12+1 trigger pattern is supported by VEMS.
do you have some initial config or configuration primary and secondary triggers for this engine??
MY INITIAL CONFIG
problem is when im crancking VEMS sees the engine speed after 2 seconds in log you see when im starting crancking the battery level going down and after 2 second vems see rpm
trigger log
vems log
This issue (long cranking with simpletrigger + camsync has since been fixed) for more details see: GenBoard/UnderDevelopment/FirmwareChanges. Upgrade firmware to 1.2.16 to make use of this fix - DB
cranking fix is working good
new problem secondary trigger pos bad
trigger log
vemslog
A: This trigger error can be safely ignored for now, it sometimes comes up because conditions for it are a bit too strict, this will be fixed in up coming release under testing. -DB
LAUNCH CONTROL DONT WORK
When im activate switch on my clutch launch flag is green but dont work when im revs my engine speed is the same at rev limiter (7000) on launch i have (4000rpm)
when im turn launch always on then work perfect
vems log