Update:
ECU #857 is now up and running/driving in the 1993 VW Passat GLX (VR6 Engine)
Configured as my "Motronic68" Plug-n-Play ECU.
Engine started up on the first try as always :)
---
Old: This VEMS was used for another project instead:
http://www.vems.hu/wiki/index.php?page=MembersPage%2FKevinBlack%2FVWGTI
This project will be continued later
___________________________
Project VW Passat VR6
- Demo/Test Vehicle for VEMS V3.3
- VW VR6 6 cylinder engine
- Firing order 1-5-3-6-2-4
- Sequential fuel injection
- 60-2 VR crank trigger
- 1 Window hall cam trigger
- NTC temp sensors
- Standard TPS
- 2 OEM knock sensors
- High-Z injectors
- 1992-early 1993 models have distributor ignition with active coil.
- late 1993+ has 3X double ended active waste spark coil.
- 2 wire PWM Bosch Idle Valve (min/closed duty ~25%)
- Bosch #0 280 140 512/ VW #034 133 455B,2 wire, 8.2 Ohms (~1.5A)
MSQ File: http://www.vems.hu/files/KevinBlack/Lugnuts2.msq
TODO:
- Find time to work on the car!
- Scope Idle valve,Tach signal,Injectors,Ignition DONE
- Idle 100hz,4.4ms at idle (44%DC)
- Tach +10.8v, 66% DC "on", 3 tach signals per rev
- Injection pulsewidth: 3.2ms warm
- Ignition: 4.8ms dwell at idle, 13.8vbatt
- Measure resistance curve of temp sensors
- Install and configure v3.3 board
Current Order:
- 1-wire interface: NO
- Ignition driver: 4+4
- Knock and EGT: Yes (2 knock,1 EGT)
- LCD and PS2: Yes
- MAP connection: Onboard 400 kpa)
- Power Flyback: 30v bidr
- Primary_trigger: VR (60-2 wheel)
- Secondary_trigger: HALL (one window)
- Lower (than 510 Ohm) resistors for i259 logiclevel outputs for use with VAG 1.8T COPs
- OEM Bosch temp sensors
Build notes:
- Board_version=v3.3
- Serial_nr= 857
- pump-= 4.14V
- wbo2_pump_pw_zero=0x67
- pump+= 4.14V
- (C103=1nF, no D100)