Wiring Page
Ignition
AEB 3 wire passive COP coils
Running in wasted spark initially
Dual Output Mode
Outputs (traversed backwards):
"0" Select 6+7, Pins 24,10
"1" Select 2+3, Pins 34,36
O/P...Output# Pin # Cylinder #
1...........2..........34...........1
0...........6..........24...........3
1...........3..........36...........4
0...........7..........10...........2
Injectors:
Pin # Cylinder
7...........1
19..........3
8...........4
20..........2
Analog Inputs:
ch 5 ec18 pin 16 WOT
ch 7 ec18 pin 12 Launch
Outputs:
ch 0 pin 4 Tach w/510 Ohm Pull-up
ch 1 pin 16 SPARE
ch 4 pin 3 Intercooler Pump Relay
ch 5 pin 15 FP Relay
ch 6 pin 31 Cooling Fan
ch 7 pin 30 Shift Light
For available outputs, see:
http://www.vems.hu/wiki/index.php?page=GenBoard%2FManual%2FDigitalOut%2FTable
TODO: check into using p259 outputs 2 and 3
Boost Control:
inj 7 pin 6 / "G" / "6" in the h[0] Injector Output Table
Idle Control:
inj 8 pin 17 / "H" / "7" in the h[0] Injector Output Table
To enable these, you go into the Injector Output Table, and at the bottom
"6" = 64 = enables inj 7 O/P6
"7" = 128 = enables inj 8 O/P
For Boost and Idle Control, wire a Switched 12v power to the valves. The ECU triggers Ground.
Intercooler Pump: Relay output see above.
Control: Misc Output 1 / 2,000 RPM / 50% TPS / 90 kpa MAP