This is the set up for my 1987 Alfa Milano Verde
others here
also online Workshop Manuals
http://www.users.on.net/~craigf/
see http://www.alfabb.com/bb/forums/showthread.php?t=26315
- block is now a S
- pickup will be VR on a 60-2
- COPS (Coil On Plug)
- cam trigger at some point but not yet
- use 164 intake(cut to fit) with the longer runners tuned to the S cams
- 179.91CID 2.949L
- stock injectors 18LB
- Req_Fuel 17.5ms
I guess I cut that in half 8.75ms
I changed the coil mosfet resistors to 1K (feeding the Base)and put in PNP 2N3906
at Q3 Q6 Q9 Q12 Q16 Q21
Emitter to power Collector to the outputs
COP setup
The pairs I will use so I can run wasted is
Q16,Q21 #0,#1 pin53,pin33
Q6,Q9 #4,#5 pin11,pin12
Q12,Q3 #6,#7 pin10,pin24
Injection
using old wires
need to look at the car but the diagram out of the online books page E-43
each injectors has a red wire for power via S2 relay looks UNFUSED!!!
To ECU
Light-blue/yellow l-jet pin 31
White/red l-jet pin 30
Light-blue/red l-jet pin 14
Yellow/black l-jet pin 32
Orange/white l-jet pin 33
Green/white l-jet pin 15
it looks like l-jet pin#28 Yellow/red need to go to ground to enable the S2 double relay
l-jet pin#4 Grey/green looks to high while cranking and will power part of S2 fuel pump/O²
l-jet pin#20 Pink/black looks to power S2 fuel pump/O²
l-jet pin#1 coil also goes to cluster(tach?)
power
l-jet pin#20 Red power shaired with injectors from S2
l-jet pin#10 Red/black power direct from S2