I have Genboard 3.3 (1.0.53) installed on my car, and i have some problems with those .bat files installed on my computer.
When connected to car, download-config.bat works fine, but when running generate-config.bat it doesn´t work right.
Tables.mtt is generated ok, but config.mtt have ERROR text first on every line.
At the end it says Config.mtt generated with 255 errors and 0 warnings.???
- check your downloaded config.txt in /config that it is correct
- check your /firmware that is has correct global.h in it
- if previous doesn't give any results, download new VemsMT release and replace old makeconfig.exe with the one from new package
Tried with new .exe file , but still the same...
at what com-port is your laptop communicating with genboard?
when this is another com-port as the bat-file uses then you have to edit the batfile with a texteditor to adjust its com-port. Tim
Edit your config.txt with Programmers notepad, Do not use windows notepad. There is note about this in here somewhere on wiki.
I had similar problems because windows notepad somehow mixed up config.txt and give multiple errors when trying to generate config.
Then finally editing with Programmers notepad there was many lines containig text from multiple lines.
I separated texts to their own lines, saved and everything worked OK!
25.03.07
It look´s to be ok in Programmers notepad..
Is it the global.h then what´s messing up?
I doesn´t have com port in generate-config.bat, only in upload and download.bat´s have it.
I´ve got false reading in clt and mat at lower temperatures, when temp is like +15c outside,lcd shows then +22 or +23 celsius.
CLT shows +96c when engine in at normal temp (+92c thermostat)
Sensors are bosch MAT 0280 130 039 and CLT 0280 130 068 and car is Calibra turbo
I´ve measured those, and here´s my list:
MAT
1c 6140 ohm
10c 4080 ohm
20c 2720 ohm
30c 1840 ohm
40c 1279 ohm
46,5c 1000 ohm
50c 882 ohm
60c 630 ohm
70c 459 ohm
80c 343 ohm
90c 263 ohm
CLT
-
1c 5770 ohm
10c 3960 ohm
20c 2630 ohm
30c 1760 ohm
40c 1208 ohm
50c 856 ohm
60c 607 ohm
70c 449 ohm
80c 331 ohm
90c 270 ohm
I´ve read that easytherm thing but imo it´s bit messy..
So could somebody tell me what to do to get those readings right?
What car you have? Can you give the markings on the sensors I.E. Bosch 0 280 130 026. Your measurements are very close to mine.
I have hex files to my sensors if you have the same!