I have Genboard 3.3 (1.0.53) installed on my car, and i have some problems with those .bat files installed on my computer.
When connected to car, download-config.bat works fine, but when running generate-config.bat it doesn´t work right.
Tables.mtt is generated ok, but config.mtt have ERROR text first on every line.
At the end it says Config.mtt generated with 255 errors and 0 warnings.???
- check your downloaded config.txt in /config that it is correct
- check your /firmware that is has correct global.h in it
- if previous doesn't give any results, download new VemsMT release and replace old makeconfig.exe with the one from new package
Tried with new .exe file , but still the same...
at what com-port is your laptop communicating with genboard?
when this is another com-port as the bat-file uses then you have to edit the batfile with a texteditor to adjust its com-port. Tim
Edit your config.txt with Programmers notepad, Do not use windows notepad. There is note about this in here somewhere on wiki.
I had similar problems because windows notepad somehow mixed up config.txt and give multiple errors when trying to generate config.
Then finally editing with Programmers notepad there was many lines containig text from multiple lines.
I separated texts to their own lines, saved and everything worked OK!
25.03.07
Doesn´t work either....
I´ve got false reading in clt and mat at lower temperatures, when temp is like +15c outside,lcd shows then +22 or +23 celsius.
I´ve measured those sensors, and there´s my list:
MAT
1 6140
10 4080
20 2720
30 1840
40 1279
46,5 1000
50 882
60 630
70 459
80 343
90 263
CLT
-
1 5770
10 3960
20 2630
30 1760
40 1208
50 856
60 607
70 449
80 331
90 270
I´ve read that easytherm thing but imo it´s bit messy..
So could somebody tell me what to do to get those readings right?