I have used motec on GSXR1000 last year in a team which I had worked in. Motec M-800 is great but it is expensive. Genboard seem to have same or superior hardware specifications.
NEW, Motuner ecu tuning software
MembersPage/JoseLCortes/Motuner
Genboard Racing Functions
MembersPage/JoseLCortes/GenboardRacingFunctions
GSXR1000RK3 Engine Sensors Description
MembersPage/JoseLCortes/EngineSensorsDescription
Ignition timing accuracy test with Genboard_v3/Firmware2004-11-24_v11_2
MembersPage/JoseLCortes/IgnTimingAccuracy
My engine started with Genboard working in fully sequencial ignition (with COP´s)!!!
MembersPage/JoseLCortes/FullySequencial
Motorcycle Engine eddy current dynamometer
MembersPage/JoseLCortes/EngineDynamometer
The R1 engine is here!
 |  |
| 122_2281.jpg | 122_2289.jpg |
Our mision is to install a Motec, but I hope to get install and test genboard in this engine, it is completely new engine, from a absolutely 0 km motobike!!!
First cycle strange firing sequence report 17-October-2005
The first turn during crancking seems to apears strange firing sequence it makes a ugly explosions during start process and dificult the starting process.
I have checked that it is not a ground loop or any electromagnetic noise. (in fact, now i am testing it with a simulator)
- latest firmware version used: v3_firmware_1.0.18
- http://www.nmine.com/msavr/config.txt (updated 17-10-2005)
- http://www.nmine.com/msavr/tables.txt (updated 17-10-2005)
- h[2]=03 02 01 00 03 02 01 00
The above config file has some questionable settings, this is what I came up with for that engine:
tooth_wheel=07 # 8-1 teeth
trigger_tooth=01
another_trigger_tooth=04
crank_minper=FF
tooth_wheel_twidth1=0A #45 degrees (0-720deg = 0-160 fake degrees)
tooth_wheel_twidth2=14 #90 degrees
cam_sync_r_edge_phase=0A
cam_sync_f_edge_phase=0A
reset_engphase_after=82 # The trigger tooth after the trigger tooth at 540 degrees (585 degrees) 585/720*160=130 (82hex)
-Jörgen
I have no multichannel oscilloscope so I built a "channel multiplier" with resistors:
-Ign Channel 00 - 9.4k lower pulse
-Ign Channel 01 - 4.7k
-Ign Channel 02 - 2.2k
-Ign Channel 03 - 1k higher pulse
It is diferent than old testings, this time the sequence is always exacly the same. Only two ignition firings are erroneous.
Jose L Cortes
joseluis_jlc at hotmail dot com