I have had various problems with the new trigger error analysis on C004 cars. After the attention it has had over the last weeks I fear that this last problem may be a configuration issue. In any case the car runs fine.
Car: Nissan 200 S14, custom harness.
Primary trigger: Honeywell 1GT101 reading two teeth on the crank.
Secondary trigger: Reading single slot in CAS with 24+1 wheel.
Trigger used: C004
Error reported: Trigger error, Secondary position bad.
Reported secondary trigger angle at idle(with reported error):85-95deg.
When testing the same config on the bench the same error was reported and it remained the same when changing the trigger timing from 0-360 degrees. Only flickering one or two "less secondary trigg" when passing the primary trigger pulse.