As my Genboard v3.3 seems to be installed, I will now try to dig through the configration.
I have studied MembersPage/BenNesbitt, who also has a V8 Audi, but he has coil-on-plug ignition, so not entirely applicable to my project.
Ignition.
- 1989 Audi PT 3,6 liter 32valve V8
- trigger: Primary-VR, Secondary-HALL
- firing order: 1-5-4-8-6-3-7-2
- ignition type: wasted spark
- coils: two 2*2 coil packs (Bosch 0 221 503 407)
Cylinders firing together are:
1 5 4 8
6 3 7 2
The coil packs are connected as follows:
EC36-pin35 to Coil 1
EC36-pin33 to Coil 2
EC36-pin34 to Coil 3
EC36-pin36 to Coil 4
Therefore cylinders are wired as follows (see GenBoard/Manual/DigitalOut/Table for driver channel numbers):
Cylinders 1 & 6 to Coil 1 to EC36-pin35 drive00
Cylinders 5 & 3 to Coil 2 to EC36-pin33 drive01
Cylinders 4 & 7 to Coil 3 to EC36-pin34 drive02
Cylinders 8 & 2 to Coil 4 to EC36-pin36 drive03
- ignchmax=03 (03..00)
- IGNITION OUTPUTS TABLE: h[2]=03 02 01 00 07 07 07 07
- going from index 3 downto 0, the drive00, drive01, drive02 and drive03 will be fired, in this order. The indexes 4..7 do not matter, 07 was chosen as (a likely nonused channel). h[2]=03 02 01 00 03 02 01 00 would also work.
This spark table can be used, right?
Be sure to get the base timing (trigger_tooth and igntdcdelay) right.