Switching to Genboard on my Golf racer, because K-Jet isn't cutting it. Later on I will be doing forced induction, so I need room for change.
Pictures and some info:
http://proton.shadowflux.com/vwracing/
email james at shadowflux dot com
Progress report (Nov 11):
Firmware r023
Starts and runs! Idles fairly smoothly with only set-screw holding throttle body at 4-5% open. Drove around a little bit, runs very well and all parameters look good. Accelerates much harder than when K-Jet was running the show, until it gets to the sections of fuel map I haven't tuned. I'll be reviewing logs today, updating tables and doing more testing, provided the rain stays away. Thank you, everyone, for your help!
- Notes:
- * VE table values had to be doubled even though req_fuel was set at value recommended by req_fuel calculators.
- * Top dead center after trigger was retarded by 30 crank degrees.
- * Use MegaTune to enable/disable features (misc_out, boost control, iac, etc). Disable values in config.txt inconsistent between feature channel outputs.
- * LCD display is cutting out, displaying with strange offsets, otherwise acting funny. Vibration getting to headers or wiring elsewhere? Will test.
Config
Latest/revised comments config: MembersPage/JimW/Config
Notes about subsystems (to verify/justify config variables) on pages below
- MembersPage/JimW/FuelSystem
- MembersPage/JimW/InputTrigger
- MembersPage/JimW/IgnitionOutput
- MembersPage/JimW/AirFeed
- MembersPage/JimW/Wiring
- MembersPage/JimW/Sensors
My Genboard and LCD display:
