Current state:
Used MembersPage/PhatBob/UserGuide and [VemsMT1.0.30rc3.zip]
I'm using a BMW M20 6 cylinder engine simular to MembersPage/GergelyLezsak
It uses the following sensors and injectors:
- 440CC injectors
- Stock single coil distributer
- VEMS Internal Map sensor (working)
- VEMS shop IAT sensor (values below)
- WB02 5057 sensor (working)
- Other CLT sensor (values below)
- Volvo TPS sensor (working)
- Stock VR sensor (working)
'11-04-06'
It runs but I still haven't connected the ICV. It's realy rich according to lambda readings but it's nice to hear it run again.
I still have to check all readings because I don't trust them jet. Hopefully I'll have time to do that next.
- Connect ICV
- Tune the settings
IAT and CLT:
[/MembersPage/JanSaenen/Tempsens]
'Fuelpump'