- 60-2 VR-Trigger
- 480cc High-impendance injectors (4 pieces)
- standard-knock-sensor (Bosch-one)
- standard-tb-sensor
- standard coolant and air-tempsensors
- standard idle-controller (stepper-motor)
- Bosch-Wideband O2 directly connected to VEMS
- EGT-sensor mounted in costummade exhaust-manifold
- internal 300 kpa sensor
- exhaust-bypassvalve the the last DIY-exhaust-silencer, controlled with 3-way-valve and vacuum
Boost control
driving the turbowastegate over 3-way-valve or manual boost-controller-valve.
Will have a look, what's easier and goes better :)
Electronic boostcontrol gives you better control, better drivability (by TPS-downscale of boost-target) and lower lag-time.
With more logged information, and with the asymetric control alg as option, tuning it is getting easier (it was hard before).
Ignition transformers
double-ignition-coil (wasted spark?)
but also coil-on-plug-type (what type ? needs logic-level or power outputs?)
my answer: yes, it's wasted spark-coil, but the complete module sit on the sparks. But inside the module there are only 2 coils, not 4. Have do drive the coils with power-outputs.
Water-injection
any detailed plan on this ?
my answer: I drove the waterinjection on the last project. I think I was a 230cc/min nozzle, with 12V 10 bar pump.
Have to calulate, when I have to start with water-injection (I think at about 15 PSI of boost + which RPM?!... Have to calculate it).