Audi URs4, 20VT, AAN engine
Problem is that triggerlog shows no secondary trigger or spark events whatsoever. As well as no rpm while crancking. Primary trigger seems fine. Hopefully someone could take a look at my logs.
At the moment everything is stock, besides VEMS V3.6 and NTC type IAT sensor. Running firmware 1.2.2
[vemslog, config. and triggerlog]
Hello Iwbs,
I have reviewed your config and triggerlog, indeed no secondary triggers present.
Lets start with the basics, how have you wired up the trigger part of the ecu (e.g. which sensor is connected where)?
My investigation shows this board (not assembled ecu but main board only) with serial v3_u009467 was sold to a reseller who must have manually assembled the ecu himself, i would advise you to contact the person you bought the ecu from, most likely there is some board setup error; in any case he should be able todo bench trigger testing for you to confirm good ecu operation.
Best regards, Dave