What we have at the moment is: BMW 325iX with stock M20B25 (inline 6 cyl) engine planned to be turbocharged, but before it the GenBoard v3.x should take its place on the car.
As I am not an electronics expert, any help from others who have successfuly managed to install Genboard on their cars will be appreciated!
As we have a spare engine, while studying / installing Genboard these changes will be made on it and later it will be installed on the car in the place of the stock engine:
- larger 440cc low impedance injectors (available at the moment);
- head porting, slight combustion chamber changes;
- custom inlet, outlet manifolds;
- lighter valve retainers, rods, flywheel etc.;
- turbocharger;
- ignition: [COPs] from BMW M52 engine
Shopping cart:
- 1 x Assembled v3.3 controller
- ignition driver: 6+2; (this means 6 power "IGBT" outputs, 6 of which you apparently plan to use; and 2 logic-level - these will be unused)
- Knock and EGT: yes;
- LCD and PS2: yes;
- MAP connection: 250kPa onboard;
- Power Flyback: yes;
- primary_trigger: VR;
- secondary_trigger: Auditrigger;
- 1 x EC36-harness
- 1 x EC18-harness
- 1 x Wideband O2 sensor
- 1 x WBO2 connector
- 1 x EGT sensor
Q: What else is needed?
Links to similar engines
- MembersPage/GergelyLezsak
- MembersPage/BengtR
- search for BMW on SiteIndex