The car is a Kadett C with a Calibra 2,0 16V C20XE engine mounted.
2006.09.28
MT also say "trigger-errors" when I'm using stimout (mstBAmsp02) :( ??
I listed my trigger-settings at the bottom af the page. The only thing I'm not sure abouth is "trigger_tooth". I've seen both 02, 08 and 10 in others config-file (with 60-2 tigger). What does it mean? Can any one see any thing wrong with my ttrigger-settings?
2006.09.25
I tryed using stimout generating a 60-2 trigger signal to trigger the board. I did not see RPM in display going to 0000rpm once in a while like when using wave-file from PC made by "Trigger signal generator".
- after using Terminal (eg. to start stimout), you need to say bye (say byebye -lowercase! - just to be sure, it'll respond with Bye). Other wise you will NOT be able to connect to MT (MT says "trigger-errors" if the W.. counter is above 10 on mlp01 LCD page).
Any one who has experienced similar problem when using "Trigger signal generator"? http://www.vems.hu/wiki/index.php?page=ElectronicDesign%2FTriggerSignalGenerator
- make sure to use a recent version, preferrably the one that takes 100-300-8000 format and makes output filename itself (from the input options). I use audacity (on windows and linux too) becuase it's easy to verify waveform
- I don't know what version it is, I just downloaded the one that is linked to on the WinTools page: http://www.vems.hu/files/TuningSoftware/SignalGenerator/signalgen.zip
2006.09.19
I have tried changing threshold on LM1815 with out luck.
I'd like to try to use the board to generate the trigger-signal http://www.vems.hu/wiki/index.php?page=OutputTrigger but I need firmware V1.0.53 where MY_CONF += -D WOT_OUTPUT_TPS_THRESHOLD is enabled in the my_make file.
Hans, a firmware image with that compile option is not needed stimout is still available on the channel you select for the wot_output (for example p259, 5) outputs the pulsetrain on the fuelpump pin; (dont use the same channel for fuel_pump when using it for stimout), dont forget to add an inline series cap from stimout pin (needs to be pulledup with resistor to +5v) when feeding it into the primairy trigger pin - DB
Thanks!
2006.09.13
The engine has a 60-2 trigger wheel on crank so I tried to trigger the board with the signal-generator generating a 60-2 signal (m582 1740 200 20 1000 1000) but MT shows "trigger-errors", and a datalog shows random 0RPM one or two times every second.
http://www.vems.hu/files/HansK/datalog200609122217_trigger_errors.xls
I'm using firmware/MT 1.0.53