Hello,
I'm from Germany and have the Vems 3.xx PNP in an Audi S2 ABY.
Unfortunately, I have a lot of problems with it and I hope the solution.
With the original ECU the car is running without problems.
When I Vems connected with the car, there is no ignition spark, and what I find so strange when you start in Mega Tune no RPM displayed wird.Also the pointer will not move!
The pin's peiden from donors for ignition timing G4 were exchanged!
Did perhaps someone such problems?
Here is the Config files.
http://www.vems.hu/files/AudiS2Turbo/mcd-saved.txt
http://www.vems.hu/files/AudiS2Turbo/mct-saved.txt
I hope the files help you to recognize the errors
I now have the exhaust voltage test to the sparkplug for coil 1
When the ignition is on, it is 0.5 V.
If I start it 1,2-1,3 V
But that is still too little and can only lie at the Vems?
Hello,
I do everything according to this guidance and with this the firmware there to invite.
http://www.vems.hu/wiki/index.php?page=MembersPage%2FBrianWeldon
Nevertheless, I have the same problem as vorher.Es is simply not!
What can I still consider check?
I test has been around for 2 weeks and I find nothing.
How can man the trigger signals on a PC in view live?
Hi, Marc Swanson here.
Did your ECU come with a hall inverter circuit installed? If so, you must make the following changes to your config:
settings->primary trigger->trigger tooth = 0 (click burn to ecu)
settings->ignition outputs: order should be from top to bottom:
Stepper D
4Stepper A
Stepper B
Stepper C
after this, you should see RPM fluctuating while cranking...
Hi Marc Swanson,
I have tried what you write hast.Leider without success.
Had an Audi S4 AAN here and there the Vems times.
Behold without Problem.Have RPM signal in a mega Cranking while Tune and a ignitionspark.
If I move the car, a speed signal and ignitionspark.
while cranking because i do not have a RPM Signal.Woran could because?
This is the same problem as users from Reidar: