Any known of any succesfull setups for a flywheel based Bosch trigger setup.
Such as Porches and early BMW´s.
Most likely two VR sensors
116 + 1 Trigger
129 + 1 Trigger
130 + 1 Trigger
132 + 1 Trigger
- Gunni
- Are you sure that those 1xx numbers are trigger teeth? -Used to think that those are starter gear teeth and the +1 is the only trigger (?)
- Gunni -
Yes, the starter teeth are trigger teeth for the ecu to know the speed, the one trigger is to located the TCD and then the ecu can know the exact location from the starter teeth.
individual power :
What is the measurement exactly?
- the difference of time spent between 2 pulses exactly 1 event apart (eg. 120 deg in 6cyl, 180 deg in 4 cyl) minus the last similar data
I was thinking that whatever it is now it might be improved upon by having it calculate the time it should take from 0-90° (or an adjustable value) only and then report the delta time as crank angles.
- inside the ECU firmware it is stored in 4 usec resolution. Of course in VT it can be displayed in crankangle (maybe it is already multiplied with RPM, or the ini can be tweaked easily).
- note that there is no "it should take" value, as RPM can change continuously. That's why - as the closest thing - it's displayed compared to last measured value (better than the average of last few).
This would eliminate variation in a complete cycle due to other cylinders and concentrate solely on the firing cylinder. Then cylinders can be compared and misfires extremely clear and potentially knock could be determinable.
- it seems the current implementation already gets as close as possible
TPS accel enrichment :
The scale in Vemstune is what appears to be millivolts against time, but there is no channel that represents this for measurement only an actual dTPS/dTime, it would be ideal to convert the scales to TPS/Time as if one where to replace the TPS with another the tuning wouldn´t have to be replaced as well as being closer on similar engines with different TPS´s.