I have the CAN BUS mockup module from the shop.
https://shop.vems.hu/catalog/stm32f103mcp2515-p-213.html
By what means can I change the CAN output Id's, scaling, offset etc? Is it pre-programmed into via firmware or is there any way of changing the config and then rebooting?
I also received a USB stick
which has 4 wires
Yellow - SWDIO
Brown - GND
Orange - SWCLK
RED - 3.3v
Inside the module there is a 4 way header pin and also a micro USB connector.
Can both be used, or just the 4 way header?