Table switchover subpage of MembersPage/GolfGtiLpg
The engine works fine for LPG and gasoline with 1.0.75 firmware with [these config and tables]. With 1.0.75 firmware a notebook is needed to switch to other set of tables.
We need to upgrade to 1.1.53 (or appropriate) firmware and make it switch controlled from EC18pin6(mcp3208 analog.ch.6). 5v / 0V
- 5V gasoline
- 0V (pulled down with a switch) LPG
Preparing the switchover tables
upgrade to 1.1.53
- upload 1.1.53
- MembersPage/GolfGtiLpg/SenzoR says
- coolantfactor "2063_256"
- airdenfactor "2252_256"
- upload 1.1.53 sanity config, eg [this]
- upload mcd and mct dump from 1.0.75 gasoline
- review missing
- knock_chan=F0
- multitooth advanced filter, see values (find on GenBoard/UnderDevelopment/FirmwareChanges when semantic changed)
- run setup on bench
- verify engine operation with gasoline
- save LPG VE and Spark tables in mct format (currently in megatune format)
- prepare slightly changed config files (confswitch=.. different)
- generate gas and LPG config.mtt files
- append the gas and LPG tables.mtt to the end
- edit the files manually, change the trailing mcs burn command to mcS0 and mcS1
Hungarian
Egy 2 körös kapcsoloval képzeltem el az átváltást és 4 db relével ezek már be is vannk szerelve.A relék 30-as pontjára érkezik a jel a cpu felöl a 6,8ohmos ellenálláson keresztül. A reléktöl a 87a-kivezetés a benzinhez megy a 87-es pediga gázhoz.A reléket viszi az egyik kör a másik pedig a cpu-ba megy mégpedig a ECM18pin6-ra egy 2k7-es ellenálláson keresztül.
Ecm18
- EC18pin6(mcp3208 analog.ch.6)5v
- EC18pin12(mcp3208 analog.ch7)5v
- EC18pin16(mcp3208 analog.ch5)0v