Buy list
Project 2: MembersPage/GergelyLezsak/BigSixTurbo Attila's E30 turbo (M30 3.4), mechanically in finish and preparing to control!
- Assembled(?) GenBoard V3.3 set up with:
- complete alu case with all the plates and connectors
- 8 ignition conf
- 8 injector FETs always included
- 2 knocks and one EGT
- LCD and ps/2
- off-board MAP
- normal flyback config
- MAP sensor - external (MPX 2.5bar should be enough)
- we only have 4bar (packaged) enginebay-MAP. 2.5 bar only available onboard (at the moment).
- Pressure hose (1 m)
- IAT sensor (NTC)
- EC36-Wire
- EC18-Wire
- LCD with wire
- and a pair of DSUB9, some cable
- WBO2 LSU4 sensor & connectors
- some silicone wire
- econoseal crimping tool
- Wires and plugs -- got it (whole harness form junkyard)
- Fuses and housing -- got it (whole harness form junkyard)
- TPS sensor pot-style if necessary (maybe not)
PINOUT request
Requested deviant setup: pins which differ from webstore's [assembled controller] :
- RS-232 : DSUB on endplate
- MAP IN: EC36 pin29 (are you sure? - no, but mine is on it. If there's a new recommendation (EC18-pin6?) which doesn't hurt, then OK.)
- KNOCK A & B
- Suggested EC18 pin2 and pin3 for knock. OK, let's go for recommended pins, BUT still we need to leave knock GND, to get both channels
- extra ADC inputs
- EC18pin12 (well, standard, since seconardy trigger is HALL, not auditrigger)
- EC18pin14 and EC18pin15 can be extra ADC as well
my (original) pinout is: [xls]
Project 1: my own E30 turbo (M20 2.5), project is almost done.
- Wires and plugs -- got it (whole harness form junkyard)
- Fuses and housing -- got it (whole harness form junkyard)
- Silicon shielded wires -- got it (~5m)
- M18x1.5mm/thread nuts to weld into exhaust (for wbo2) -- got it
- MAP sensor (MPX 2.5 bar) -- got it
- Pressure hose (1m) and T-shape. I've got 2 pipes from intake manifold both are d=4.5mm. One is for adj. FPR, one for boost gauge. -- got it
- IAT sensor and some sort of mounting -- got it
- GenBoard 3.3 and rescue kits
- TPS sensor -- got it from junkyard, made mount from sheet of plastic
- EC36-PCB -- got it on board
- EC18-PCB -- got it on board
- EC36-Wire -- got it
- EC18-Wire -- got it
- LCD with wire -- got it
- and a pair of DSUB9, DSUB25 some cable -- got it
- LM1815 chip for cam signal -- got it on board
- ps2 extension cable
- USB to RS232
- WBO2 LSU4 sensor & connectors -- got it
- EGT K-Thermocouple and compensational wire -- got it
- AD597 K-Thermocouple amplifier -- got it on board
- TPIC8101 -- got it on board
- 2x MCP3208 -- got it on board