Hi,
I've assembled the PCB and upgraded the firmware.
All was well with only a 1 amp fuse needed in the power feed to pin 25.
I then fitted it to the case and clamped down the FETs and IGBTs.
The Insulating sheet was already fitted to the case when it arrived.
It blew the fuse in the feed to pin 25 as soon as I powered it up:(
I removed it from the case and the PCB is still drawing 2.5 amps.
I've not connected any coils, injectors or sensors to the ECU, just the power to pin 25, the 5 grounds and the RS232
If anyone can suggest what to check.....
Thanks :)
- Try to connect only + to pin 25 and Gnd to pin 26 then you should be able to connect with megatune. If the fuse blows then there is another problem
Normally you only need four Gnd i.e. pin 5, 21, and 32 is Power Gnd´s and pin 26 is the processor Gnd.
See this diagram http://www.vems.hu/wiki/index.php?page=MembersPage%2FPeterJensenwiring