VAG test-engine in a dyno cell (for student-education)
Take as much notes as you can
- 4 cyl (firing order 1342)
- 1.4 liter
- VW engine code ?
- since the install is urgent, [ECU options] should be determined immediately, controller can be built after that !
position sensor reminder:
- if you find 2 pins that measure same resistance with BOTH polarity (eg 500 Ohm, but can be different: usually between 300-1400 Ohm) than it's VR.
- Otherwise HALL.
VR or HALL ?
VR or HALL ?
probably no pedal at the moment anyway, manual bypass air will be used
apparently very similar to the logiclevel ignition also used on "skoda". Note: damaged if connected wrong so research needed. Try to find GND and +12V from the factory harness
