I'm trying to connect HALL to both primary and secondary inputs on my development board.
This is what I've figured out:
The red areas are +5V, probably good to use as pullups.
Trigger 1 is the magenta area; it needs a resistor (not pictured) at the voltage regulator to get there.
It should connect to the cyan area, which is the input pin on the atmega.
Trigger 2 is the Yellow area; it should connect to the Blue area.
Does anyone have a good idea on how to make all these connected?
- trigg2= R91 stuffed D24 should be a short and D27 a 5.1V zeener SJ5 shorted
- trigg1=R55 stuffed D13 short D14=5.1V zeener SJ2 solderd