Hi.
Need some help on building an plugnplay-ecu for an old 10v urquattro running a 25pin toshiba ecu.
Its running the standard three sensor Auditrigger.
Ive connected the Primary VR sensor to EC36/27.
Should I connect the Hallsensor to EC36/13?
Where on the board should i connect the Secondary VR sensor?
Board Serialnr 3919 . Ordered with Auditrigger setup.
Thanks for all your help!
Ive come this far:
Connect the sec VR trigger like this black and red wires
You may need a 1.5 kohm resister mounted on solder side at ends of wires. (Pull down)
