Trigger related page for MembersPage/EricN
truck is a 6 cyl. I am firing cop coils and using a distributer mounted trigger wheel. Tooth count is dependent on what sensor I get working
Board is a v3.2 serial number=110
MembersPage/EricN/Trigger/Optical
Going to try this for now.
- so much for that idea.
This page hopefully all garbage. I cant get the input trigger to stop cutting out (happens at any rpm all the way to redline) no matter what I try.
OPTICAL TRIGGER DROPS OUT LIKE VR DOES
Built an optical trigger. 12 teeth, set to coil type ignition. Use rising or falling edge makes no difference. Use filtering or not, makes no difference. Trigger drops out at any rpm, seems worse at low speed but not by much. Loose fuel pump, injectors and ign.
Is there anything config related that could cause vems to cut out that is not rpm related? Keeping in mind the test bench has no sensors hooked up at all, just a input trigger and fuel pump relay.
Next step will be to build some plug in motor to spin the trigger wheel since my drill batteries keep dying and turn it on and use a scope and follow the input trigger traces that are shared with VR and Hall type setups. If that fails, back to points and a carb since I messed up my optical trigger for my aftermarket ingnition.