Trigger related page for MembersPage/EricN
Started over with input trigger ideas. Took a VR sensor and 24 tooth trigger wheel out of a Honda Civic distributer. Ground off 1 tooth, pressed it on to a gutted Unimog distributer (took the whole advance mechanism out). Welded a plate inside, mounted the VR sensor on the plate. Now I have a 24-1 trigger wheel driven by the cam.
Nice! Can you take photos ?
My plan is to run as a 12 cyl (engine is a 6) pretending to fire wasted spark so I can use the COP coils. I thought I read somewhere about setting the number of cycles that will trigger a reset (not sure if I worded it right but meant that engine sees the missing tooth 2 times then it starts over) Not too sure if setting that to 1 cycle would work somehow, need to try and find it again.
- tooth_wheel=17 # (decimal 23 for 24-1 tooth wheel)
- trigger_tooth=00 # (or 01, 03 or 03)
- another_trigger_tooth=04 # (to fire 6 times every crankrot)
- divider=01
- alternate=15 # 6 injector banks; fire all banks at cranking
- ignchmax=05
h[0]=01 02 04 08 10 20 40 80 # change if wiring differently
h[2]=01 03 04 06 07 08 05 05 # the last 2 entries not used with ignchmax=05. Note that channel 2 and 5 recommended as spares (not populated in the 6-driver version assembled unit).