This is MembersPage/EricN collection of links that I have found helpfull and ones I have found and am not sure how to find again. As well it is also my buid diary so I know what to do next time. None of the pics are my own, everything is off this site.
Use the [Manual page] if I forgot something and search for it there.
V3.2
DONE/DOING LIST
Notes stolen from elsewhere to organize into here later
Setting up 36-1 trigger
Edge = rising
Type = multitooth
Filtering = Disabled
TDC after the trigger (vr sensor) deg =??
Number of teeth on the wheel = 35
36-1
Trigger tooth = 1
Number one tooth after the missing one
Next Trigger tooth = 18
Crank min period usec = 3000 (assuming a 4cyl that is 6000usec for a whole crank rotation, which is 10000 RPM)
reset_engphase_after=decimal 216 (which is an arbitrary number for 720 crankdegrees, practical for 36 tooth wheel). The values below are in the same unit:
Angular width of tooth = 3 (10 degrees)
360/36=10
Angular width of missing tooth = 6 (20 degrees)
http://vems.sourceforge.net/manualhtml2/ch03s02.html this page]for pinouts and wiring diagrams