This is my collection of links that I have found helpfull and ones I have found and am not sure how to find again. As well it is also my buid diary so I know what to do next time.
DONE LIST
- Soldered connector to board.
- Make [Serial Cable] and connect it to your PC and Connect the other end to your board.
- Power the board. Out of fear, holding everything in my hand to feel if anything getting hot
- at (with 1A fuse) EC36 pin 25 (+8..14V)
- and (-) EC36 pin26, EC36pin5 (EC36pin21, EC36pin32). Be certain to connect at least one GND5 too. While this is not strictly necessary if no load is driven from the power-GND5 plane, we better condition everyone to always have as many GND5 connected as possible (3..4 in a production install)
- Download and open Bray terminal. Use [this link] and follow his instructions. If it works, good, if not, make sure you used a capital M in Man and com port is correct as well as your cable is built correctly.
- Download the [firmware] make sure it is the latest release.
- Downloaded and installed [winavr] so you can have programmers notepad, only need it to enable wb 02 in my make, (I dont know of another way) more on that later.
- Downloaded and installed avr studio 4, cant find the link now.