Trigger setup for Audi S4, 5cyl Direct Fire engine
- Primary trigger is VR 60-2 multitooth
- Secondary trigger is a hall sensor, 10-20 Deg Slot fully adjustable (mockup distributor)
- What is the best way to configure this ?
- firmware modification, done in 1.0.24 (ready for testing)
- If we set another_trigger_tooth to 12 (5 per crankrot), and extend the h[2] table to 10 cells, and set dummy values every second cell, also for injectors, divider=02. I guess it would work?
- it would work, but with current stable firmware dwell-time would be limited at high RPM. In short, not a good solution.
Config http://linkopingsmotorsport.se/config.txt
Tables http://linkopingsmotorsport.se/tables.txt
Datalog: http://linkopingsmotorsport.se/datalog200511141121.xls
bad values
- another_trigger_tooth=0C (should be 0x18 = decimal 24)
- crank_minper=A9 (should be lower, like 0x50 or decimal 80)
- ign_crank_advance=00 (I guess it will be adjusted later)