Trigger setup for Audi S4, 5cyl Direct Fire engine
Audi 2,2T AAN engine
Now with orginal trigger
ECM: 3.3 #332
Modified to accept auditrigger
- added lm1815
- added 100k resistor at R182
- added wire, ec18pin12 to R90
- measure at lm1815 pin3 that this signal comes through (with scope)
- added blob at SJ7
- also scope here to see the signal mix from distributor and sec lm1815 output.
All sensors original except for map/iat: Bosch 0 281 002 437
Firmware 1.0.29 00:21
Config http://linkopingsmotorsport.se/1029/config.txt
Tables http://linkopingsmotorsport.se/1029/tables.txt
OldPage with 60-2 + camsync. Had runout and very little space to fix triggerwheel
See also