This is my shopping list. Please tell me if you see something wrong. I have put in some chips that might not be necessary, but it's better to have some not needed than wait and pay freight for some low cost hard to get parts later.
Where not mentioned, Qty is one.
- GenBoard3.3
- Blue LCD
- Alubos1600 case
- 6 holes
- Gasket
- 2 needed, front and endplate
- Endplate
- Available with DSUB cutouts?
- EC Front
- 2pcs. VR Coil chips LM1815
- Only one needed, one is included with the 3.3 board
- 2Ch Knock sensor Chip
- EGT Amp chip AD597AR
- Room for 2 on the board, its better to solder them both right away, even if you only need one
- Opamp LT882IS
- Not necessarily needed for operation
- Econoseal-18 PCB
- Econoseal-18 Wire
- Econoseal-36 PCB
- Econoseal-36 Wire
- Adressable Latch TPIC6A259DW
- One of these are installed from factory too.
- Idle stepper driver SN754410
- this is not needed for that volvo engine, it has a solenoid for idle control, not stepper
- Qty: 8 Ignition driver HGTP14N40F3VL/IRGB14L40C
- Cost isnt too high, its easier to clamp the box with all of them in place
- Qty: 9 Inj/WBO2 heater driver FQPF20N06L
- support for 8 high power inductive loads, (injectors, idle solenoid etc..) and one WBO2 heater
- Power flyback,no wires
- 250kPa MAP sensor MPX4250AP
- EGT sensor K-type
- 4 Pcs. Hall sensor TLE4905 Unip.
- K-thermocouple connector pair male+female
- 5Pcs.Temp. Sensor NTC 2K2
Additional cost to get early shipment?
Freight cost to Norway. ??