Information from Webshop:
Board_version=v3.3
Serial_nr= 1057
pump-= 4.17V
wbo2_pump_pw_zero=0x68
pump+= 4.23V
(C103=1nF, no D100)
Engine information:
* Opel C20NE engine with uprated pistons, conrods, bolts, clutch etc.
* 2000cc
* 8 valve
* 86.5mm bore
* 86.0mm stroke
* 14 bar compression ratio
* 1-3-4-2 firing order
* 60-2 trigger wheel
* 4x 174 cc/min injectors
* one coil
31.8.2007
I have problem with WBO2 free air calibration. I did pump zero pw and pump(103) PID nernst target calibration(134).
This is voltage on drain of WBO2 heater mosfet. Looks good.
But level of O2 is junpig form 12% to 23% and some times ??.?
Here is log of readings
http://www.vems.hu/files/DamirMuha/lambda2.txt
Solved, pump kp term was 0:(
29.8.2007
IAC is now on pwm control and idle wokrs good(800rpm).
28.8.2007
I started my car without any problems(first attempt and it works:).
Here is film http://www.youtube.com/watch?v=I15bj_GRX-o
But I have problem with idle(is about 4200 rpm).
How can I regulate(lower) iac(standard opel on/off)
Here is my config http://www.vems.hu/files/DamirMuha/megasquirt200708281446.zip