1UZ-FE non-VVTI
What I need to know is the following and engine details will help.
This is for a 1UZ-FE Non-VVTI running ITB's
We need to connect the following
- 8 x Logic Coils (active COPs)
- IGBT NOT needed for this ! Actually max 4 IGBT, so that you have 8 logiclevel ignout (together with the +4 stepper outputs)
- 8 x High Impedence Injectors
- 1 x TPS
- 1 x CLT
- 1 x IAT
- 1 x Wideband Bosch LSU4.2
- 2 x Knock Sensors
- need 2 x knock input.
'''ECU 2410 (purchased 2nd hand)
- ignition driver: 8
- means upto 8 passive coils
- upto 4 logiclevel coils (via stepper outputs !)
- primary_trigger: VR
- secondary_trigger: HALL
- Knock and EGT: no
- so no TPIC8101 chip installed
- MAP connection: 115kPa (6/4mm pneumatic)
- LCD connection: no
- Flyback: 30V flyback
- mounting-style: screws
- PS2 connection: no
Also I've been through the software and we might have another issue. The 1UZ-FE non VVT-i runs a 12 tooth no missing teeth crank trigger with single lobe cam sensor.
We need both sensor obviously for fully sequential.
On your software it seems to only be able to choose either Coil Type or Missing teeth.
This is my first install.