Audi AAN 5cyl 20VT engine
Modifications:
Eurospec 2.6L Block (Carillo rods, Arias pistons)
ported and polished/flow matched cylinder head
GT30R .82 A/R Turbo (4" anti-surge inlet)
60 lb/hr Injectors w/ Bosch 044 Fuel Pump
Stromung 3" exhaust w/ custom 3" downpipe
RS2 exhaust manifold
Greddy Oil Catch Can
Samco boost hoses
Apikol Gen.2 Intercooler
custom charge pipe w/ HKS SSQV blow-off valve
034 Motorsports High Output Coil Kit
RS2 6-speed transmission
South Bend FE Series Clutch
JB Racing 11 lb. flywheel
2Bennett full coilover suspension (track spec)
OZ Racing Ultraleggera 17" x 8" wheels
Porsche 996TT brakes
Please measure the MAF pins in the harness
- which AANpin it belongs to (fill in table below)
- any pin connected to ground must be avoided.
- Is there a +12V pin (capable of 2..3A) for heater+ ?
We recognized that the MAF connector is simply unsuitable, because we need 4 pins (neither must be connected to GND or +5V) which is simply not available in the MAF connector. If we find 3, that, together with the NBO2 nernst signal might be enough.
Anyway, finalized pins to use for WB02 LSU4 sensor:
- AANpin...#42 (open on stock harness) pump-
- AANpin...#37 (+12V supply-flyback, voltage supplied by the AAN harness, NOT the ECU like on the 3B)
- AANpin...#43 (open on stock harness) nernst
- AANpin...#51 (open on stock harness) pump+
- AANpin...#54 (open on stock harness) heater-
- not used
Using these pins we wouldn't use the MAF plug, but would allow there to be enough inputs for the WB02.
In the meantime, review VemsAudiAan
You can do the verification measurements,