I have seen that some of you allready have the VEMS running on the Audi I5 so i think it is possible to Trigger the Timeing with the Hall sensor on the Camshaft pulley and the Engine Position Sensor on the Flywheel. My Question on you is: Are you Using the stock ABY-AAN-ADU ignition system-Coils-Stages?
Hi Vasilis,
We have run VEMS on several different (3B/AAN/ADU) I5 Audi engines in here. We've always used PlugNPlay adapter to connect VEMS to original motronic wiring/sensors and it's possible to switch back to original system in a few minutes.
Some notes according to my current knowledge:
- Stock coils and end stages are used. However, VEMS has capability to run dummy coils too (IGBTs inside ECM) so it would be possible to get rid of the amazingly expensive end stages.
- Stock sensors are used
- Engine ref position sensor polarity needs to be swapped (easy to do inside firewall connector)
- Intake air temperature PTC has very flat temperature/resistance curve, for better resolution some other sensor would be worth to think (or order with different bias resistors on board)
- Onboard computer is not showing fuel consumption etc (may get fixed in the future)
- There is still an issue with 135-tooth trigger wheel causing lost spark around 6krpm - this is thing is under investigation at the moment.
- Starting while cranking is not as quick as with motronic, but it's mostly due inproper tuning
Regards,