VEMS motronic55 for Audi ADU engine with 400 kPa Map onboard
EGT connector fitted (flying loom)
Knock: yes, via motronic55 pins
cables for anti lag, launch control and Gear switch light,flat shift and Dual stage Rev limiter preinstalled
PowerFlyback with 30V transient suppression diode
Wideband 02 Sensor + Screw
EGT Sensor with 6mm
I-Button prepared for the future (when it will be integrated in the firmware)
16x14 tables
Is it all that i need?
- Where can i find ADU config and tables for the beggining.
- config is same as AAN/ABY or 3B for that matter
- tables should be close to AAN/ABY (and changing from 3B is not complex)
- the VE is not very hard to tune (the type of turbo makes a difference here, because of different EBP) with some care and patient log-analysis
- lambda and ignition advance should theoretically be similar as for AAN/ABY/3B (as it mainly depends on the cylinder head and compression and fuel), but it's never easy to get an optimal tune for these. MembersPage/MarcellGal/PowerAndTraction has AAN config and tables, and soon 3B tables as well, but these might be conservative tables (a bit too rich at high-power and less than max power ignition advance). You rely on your local engine tuner/expert when you want to get more out of the engine.
Engine
- Audi S2 5 cyl 20 valve engine, similar to MembersPage/MiskaPeippo/AudiSSix ???
- I Dont know if MiskaPeippo Audi S6 has the Same Ignition as Mine. The pictures with his Valve Cover seems different.
I think that my Buing list will be:
- VEMS v3.x
- 4 Bar Map
- internal or external ?
- I think External will be better for Mods, installations etc
- internal or external ?
- Wide Band Sensor
- EGT Sensor
- Motronic Harness (If i find anything?)
- anyone would make a motronic harness? for how much ?
- Jörgen said they are Preparing a PnP Motronic harness for The Audi I5 and are going to be able to deliver when it is tested in a car.
- anyone would make a motronic harness? for how much ?
- LCD and Keyboard Support
- mostly useful for cold adjustment (warmup enrichment, idle valve reference positions, etc...) especially if engine is tuned in warm but used in cold as well
- LCD Display
- iButton (What is it-How does it work?)
- prevents engine from startting - in a future firmware revision
NEW BUYING LIST AFTER PNP Motronic VEMS V3.3 IS released.
Motronic ECU extra connectors
- Follow VemsAudiAan during install (measuring and uploading steps)
- it refers to MembersPage/TeppoKalske page bottom:
AAN ECU extra connector pins: (no custom preference, so default is used)
WBO2 on SSC5 male standard - applies to audi AAN and 3B (also to BMW):
- pin1 nernst,WBO2 pin 1
- pin2 WBO2 pin 3 (use a 5A fuse from +12V supply wire)
- pin3 heater(-),WBO2 pin 4
- pin4 pump(-),WBO2 pin 5
- pin5 pump(+),WBO2 pin 6
SSC6 feemale
- pin1 mcp3208 pin6,ch5
- pin2 mcp3208 pin7,ch6
- pin3 mcp3208 pin8,ch7
- pin4 EC36 pin 34 (power out)
- pin5 EC36 pin 36 (power out)
- pin6 GND