21.05.2007
New Buying List:
- VEMS motronic55 for Audi ADU engine same as ABY(with 400 kPa Map, EGT connector fitted, Wide 02 extra plug installed, cables for anti lag,Intake Air Temperature Sensor-Miska help here)
- Wideband 02 Sensor + connector
- wideband screw ? the factory exhaust has provision (18x1.5mm female thread) for lambda-sensor. Custom exhaust system might not have it
- EGT Sensor
- I-Button
- genboard can read it (via terminal-command currently so HW can be tested), but the thief-protect or valet-low-power functions are not yet integrated (2nd table and config is available though, so it is easy to integrate if you really want it, and make+elaborate on 2 set of tables/config and write a request and wait a few weeks).
Is it all that i need?
- Where can i find ADU config and tables for the beggining.
- config is same as AAN/ABY or 3B for that matter
- tables should be close to AAN/ABY (and changing from 3B is not complex)
- the VE is not very hard to tune (the type of turbo makes a difference here, because of different EBP) with some care and patient log-analysis
- lambda and ignition advance should theoretically be similar as for AAN/ABY/3B (as it mainly depends on the cylinder head and compression and fuel), but it's never easy to get an optimal tune for these. MembersPage/MarcellGal/PowerAndTraction has AAN config and tables, and soon 3B tables as well, but these might be conservative tables (a bit too rich at high-power and less than max power ignition advance). You rely on your local engine tuner/expert when you want to get more out of the engine.
Engine
- Audi S2 5 cyl 20 valve engine, similar to MembersPage/MiskaPeippo/AudiSSix ???
- I Dont know if MiskaPeippo Audi S6 has the Same Ignition as Mine. The pictures with his Valve Cover seems different.
I think that my Buing list will be:
- VEMS v3.x
- 4 Bar Map
- internal or external ?
- I think External will be better for Mods, installations etc
- internal or external ?
- Wide Band Sensor
- EGT Sensor
- Motronic Harness (If i find anything?)
- anyone would make a motronic harness? for how much ?
- Jörgen said they are Preparing a PnP Motronic harness for The Audi I5 and are going to be able to deliver when it is tested in a car.
- anyone would make a motronic harness? for how much ?
- LCD and Keyboard Support
- mostly useful for cold adjustment (warmup enrichment, idle valve reference positions, etc...) especially if engine is tuned in warm but used in cold as well
- LCD Display
- iButton (What is it-How does it work?)
- prevents engine from startting - in a future firmware revision
NEW BUYING LIST AFTER PNP Motronic VEMS V3.3 IS released.