THANKS JORGEN!
Well, I was never able to get a 'hello' from the board and in the midst of trying various things, I accidentally hooked up power backwards. Now I DEFINITELY have no hello from the board. I need help.
- what supply did you use?
- what settings ?
- voltage
- current limit
- what fuse was installed?
- what trace burnt ? upload picture, if any
- what is voltage measured with DVM diode mode (red applied to +VBatt and black applied to GND and GND5)
- what is current consumption from supply of 6..7V ?
serial
Describe your serial connection.
- ...
- ...
Test your serial cable and TerminalProgram
When cable not connected to GenBoard, connect RX and TX (pin 2 and 3 of DSUB9 RS232) and see if you see if you see in TerminalProgram.
- make sure you talk to firmware in 9600, 8n1 : say Man
- try to talk to BootLoader
- disconnect serial cable from GenBoard
- apply loopback to GenBoard RX-TX
- powerup board
- remove loopback
- connect serial cable to GenBoard
- TerminalProgram 19200, 8n1
- type 'S'
- got "AVREFI1" ?
- type 'v'
- got anything? (20?)
- type 'p'
- got anything? (20?)