Details:
1993 Audi 80/90 Quattro
1997 Audi A8 4.2 liter V8 engine with sequential injection and coil-on-plug ignition.
Using a 60-2 trigger wheel on the crank with a (I think) VR sensor from the 1993 12v V6 and the stock A8 4.2 cam position sensor (Hall).
25 September 2005//
Ok, I got my wiring hooked up and the board says Hello
I uploaded firmware 1.0.18 using perl and tested it with terminal. Deleted the 'firmware' directory in the Megatune release 024 build and replaced it with the above.
Megatune loads and gives me good temp readings but apparently there are no real .mtt files.
I cannot for the life of me figure out how to make the .mtt files from the config.txt and tables.txt
- Follow this [guide], step 4 I beleive goes into detail quite well on how to do it. Thats where I go when I upload new firmware and need to upload my tables and config.
None of the helpful hints and commands that people have sent have worked.
I also seem to have a crappy v3.2 board since pin 8 and 17 injector drivers failed the diode test with the pin 23 flyback. I don't know what to do about that since I did not build the board and planned to avoid that part of the "fun".
This car is ready to as soon as I can solve those problems and figure out the trigger arangement for direct ignition and sequential 8 injectors.
Fill in these pages with all the required info and watch your config be pretty much built for you
MembersPage/BenNesbitt/IgnitionPage
MembersPage/BenNesbitt/WBsensor
MembersPage/BenNesbitt/FuelPage
MembersPage/BenNesbitt/InputTrigger
MembersPage/BenNesbitt/IdleControl