new to the site.
ECU SPECS
Board_version=v3.3
Serial_nr= 2692
pump-= 4.0V
wbo2_pump_pw_zero=0x64
wbo2_nernstdc_target=0x86
pump+= -2.7mV/200 Ohm
AREF=4.9V
(C103=1nF, no D100)
Engine Specs:
-VW 2.0 16v ported headed. Built Bottom End
-GT35R
-EP racing manfiolds
-VEMS 3.3
-400kpa built in Map
engine build is done
Harness is in the car
wiating on some more bosch crimp end connectors to finish the last few sensors to wire
ECU POWERS ON
TODO: this week - finish wiring, testing, config sensors
Harness Specs:
-12v IGN: 12AWG to EC36 pin 25
-GND: 12 AWG to EC-36 pins 5,21,22,32,26 sensor GND wire
-Ignition: EC36 pin 34, 36 (coils 2 & 3)
-TPS: EC36 pins 1,29, grnd
-IAT EC36 pin 2
-Injectors EC36 pin 7,19,8, 20
-VR: EC36 pin 27
-Ch5 Output Pin 15 - fuel pump relay
-Ch1 Output Pin 31 - Fan Relay
-Ch4 Output Pin 3 - Shift Light
-Ch0 Output Pin 4 – Tach out
-Analog 7 EC18 pin 12 with input from EC36 pin 29 launch control