BOM for MembersPage/BasilDaham/CordobaSX
- Assembled v3.3 controller
- NO 1-wire interface
- 6+2 ignition outputs 4+4 sounds more suited for the 4cyl. Even if only 1 is used originally (distributer), and 2 (wasted spark) is best (most powerful and durable transformers available that, even with the 10% waste, output higher energy than COP coils in an inductive ignition application) for most 4cyl installs
- knock and 1 EGT
- LCD & PS2
- 300kpa onboard 5/3mm note that 6/4mm nipple is more common, check again what is best for you
- with screws mounting style
- with powerflyback
- primary trigger HALL
- secondary trigger HALL
- LCD4x20 (BLUE)
- The kit needed for a loom:
- Econoseal / JPT Crimptool
- Econoseal18-Wire
- EconoSeal36-Wire
- two wideband connectors (receptacles included, of course)
- simple connectors: (note that SSC sealed sensor connectors are MUCH better, the simple connectors are not sealed and look lame ; more suited for bench / prototyping stuff)
- two pair 3-pin simple wire to wire connector
- four pair 2-pin simple wire to wire connector
- Anything else i'm missing?