I am modifying an 88 Honda Legend. There are 2 stages to this At the moment i have a c20at motor which is a 2 litre turbo V6 that i am in the process of transplanting that i will drive while i build my secont motor. It is wired up with the wiring loom from a c27a (the original motor from the car). I am going to build a 2.7 litre turbo motor from a N/A c27a that will hopefully go in the car in about 18 months time.
I would like to design a vems computer to run this but have a lot of questions.
Just for a start off will i be able to wun it through my wiring loom with a couple of sensors added or will i need to get a new loom? I know of one othe car with this motor that it has been installed in using the original sensors.
What you are wanting to do is possible. I did it three years ago with a V3.1 board.
However, at the moment I have a problem and I can not get any support and my truck will not run. Do you have any contacts to members other than through this wiki that no one seems to read? The chat line seems to be dead.
Thanks,
Chris Gerhardt chrisgerhardt at hotmail.com